febi Bilstein Brake Discs — Pair or Single (Side-Specific)

OE-quality febi Bilstein discs engineered to restore smooth, confident braking and low NVH. Precision-machined to match your vehicle’s original dimensions for correct fit, balance and durability.

What’s Included

• Most applications: supplied as an axle pair (2 discs).
• Side-specific/directional applications: may be supplied as a single disc (Left or Right). Please check photos and listing notes to confirm. If listed as single and you need both sides, order quantity 2 (one LH + one RH where applicable).
• New locating screws/bolts are included only if shown or stated.

Pads are not included unless the listing specifically says so.

Key Features

• OE-matched dimensions, run-out and balance for vibration-free braking
• High-quality casting and accurate surface finish for consistent performance
• Vented or solid design according to the original specification
• Anti-corrosion coatings on many references to keep hubs looking clean

Check Before You Buy

• Axle position: front or rear
• Dimensions: outside diameter, thickness and minimum thickness (MIN TH)
• Type: vented vs. solid; plain vs. drilled/grooved (match OE)
• Mounting: centre bore, overall height/offset, bolt pattern and any locating screw type
• Handed discs: some vehicles use Left/Right directional discs (curved vanes or patterns). If so, ensure you order the correct side(s).
• Verify by VIN/registration and febi/OE part numbers for guaranteed fit

When to Replace

• Disc thickness at/below MIN TH or severe scoring/heat spots
• Brake judder, vibration or pulsation (after confirming hub and pad condition)
• Cracks, excessive run-out or corrosion on friction faces

Installation & Bedding-In

• Clean hub faces thoroughly; check hub run-out before fitting
• Degrease new discs (if oiled) and avoid touching friction surfaces
• Torque locating screws and wheel fixings to manufacturer specifications
• Best practice: fit new pads with new discs; ensure calipers slide freely
• Bedding-in: 10–15 moderate stops from 30–50 mph (50–80 km/h), allowing cooling between stops

Warranty: febi Bilstein brake discs are covered by the manufacturer’s warranty when supplied via authorised distributors. Correct installation and operation within specification are required for warranty validity.